Embedded Files
Projector User Guide - How to Switch On the Projector
Projector User Guide - How to Switch On the Projector
🔴 STEP 1: Turn ON the Switch
🔴 STEP 1: Turn ON the Switch
📍 Locate the PROJECTOR POWER SWITCH
• Usually found near the bed (left or right side)
✅ Make sure the switch is ON
• Indicator light must be ON
❗ IMPORTANT NOTICE
If this wall switch is OFF, the projector WILL NOT work, even if you press the projector remote.
STEP 2: Press POWER button on projector or remote
Wait ±30–60 seconds for startup
STEP 2: Press POWER button on projector or remote
Wait ±30–60 seconds for startup
System will auto adjust Image
System will auto adjust Image
Auto Focus
Wait for auto focus to finish
If not sharp → press FOCUS / adjust manually in SettingsKeystone Correction
Auto keystone usually runs automaticallyIf image still tilted →
Settings → Keystone → Adjust
🔴 POWER OFF – VERY IMPORTANT
🔴 POWER OFF – VERY IMPORTANT
✅ The projector MUST be turned OFF after use
Use the projector remote to power OFF the projector
Wait until the fan stops completely
❗ IMPORTANT NOTICE
If the projector is not turned off after use, it may cause screen burn / image retention.
⚠️ Responsibility Notice
If screen burn or damage is found due to the projector being left ON, the guest will be fully responsible for the repair or replacement cost.
Page updated
Report abuse